Aqua Rite Chlorine Generator Turbo Cell - NC312 is used with the Aqua Rite electronic chlorinator, Aqua Trol above-ground pool automation control, or the the Aqua Logic in-ground pool/spa automation control to generate fresh, pure chlorine to meet the pools sanitization needs.

The Aqua Rite Chlorine Generator Turbo Cell - NC312 can be installed vertically or horizontally in the pipe return pipe to the pool. Whenever the filter pump is operating, the Turbo Cell will be converting a low concentration of salt in the pool water into chlorine which is then evenly dispersed thorughout the pool via the return jets. It couldn't be easier, more effective or trouble free.

• Union connections (2 inches) for easy installation. Use standard plumbing adaptors for 1½ inches pipe; 50 millimeter unions also available. Model T-CELL-15 has fittings for both hose and return jet connections.


• Cord with plug at the control end ensures that all electrical connections are protected from getting wet.


• Standard cable length is 15 feet (4.5 meter); cells with 25 feet (7.6 meter) cables are also available.


• Large diameter minimizes flow restrictions. Can be used on high flow systems required for in-floor cleaning or water features without the need for a bypass. See chart for flow vs pressure drop curve (as tested by NSF).


• The Aqua Rite Chlorine Generator Turbo Cell's (NC312) offset design creates a turbulent flow pattern that maximizes the self cleaning performance.

• T-CELL-15 for Aqua Rite and Aqua Logic generates up 1.45 pounds (.66 Kilogram) of chlorine
• T-CELL-5 for Aqua Trol generates up to .87 pounds (.40 Kilogram) of chlorine.

• Cell cleaning frequency will depend on ph and calcium level in the water. This will tell on how often the cell requires cleaning.


• Maintain pH at the levels recommended in the Operating Instructions (7.2 - 7.8) should result in cell cleaning 3-4 times a year in areas with hard water. Cells can be cleaning less frequently in soft water areas.


• The Aqua Rite Chlorine Generator Turbo Cell - NC312 will require maintenance when the "Inspect Cell" light is either flashing or is on solid and the salt level is confirmed to be above 2500 part per million.

1. Turn Filter pump off.


2. Remove the cell from its position in the plumbing by loosening the unions on both ends of the Aqua Rite Chlorine Generator Turbo Cell - NC312.


3. You will need a small plastic bucket (6 - 8 inches opening), water and muriatic acid. (Picture A)


4. Fill the bucket with 3 - 4 inches of water. (Picture B)


5. Set the Aqua Rite Chlorine Generator Turbo Cell - NC312, on end, in the bucket of water. (Picture C)


6. Add 1 - 1 1/2 inches of muriatic to the water in the bucket. Let the cell sit in this solution for 5-10 minutes. (Picture D)


7. Turn the cell over and let the other end sit in the solution for 5 - 10 minutes. You will be submersing the cord, which will not be affected by the mild acid solution. (Picture E)


8. Look in both ends of the cell to confirm calcium deposits are removed. If not, repeat cleaning procedure.


9. Rinse cell with fresh water and replace in plumbing line. Hand tighten unions before restoring power to filter pump.